Foam-applied sealant engineered for rapid hydrophobic protection.

This is an amazing new product, it is not a car wash soap.  It is a foam applied sealant.  You need to rinse it off immediately, don't let it dry or you will get high spots that are difficult to remove.  

Advanced siloxane and SiO₂ silica polymer technology forms a crosslinking
protective layer on paint and coated surfaces.

• Foam on. Rinse off. Hydrophobic protection remains.
• Creates strong water beading and surface slickness.
• Enhances gloss and hydrophobic performance.
• Leaves a thin crosslinked polymer protection film.
• Mild acidic pH supports polymer bonding to paint and ceramic coatings.
• Touchless application. No wiping required.
• Engineered for fast, simple protection after washing.
• Apply using a foam cannon or foam gun to a clean, wet vehicle, then rinse
  immediately.

Safe for paint, clear coat, trim, wheels, and ceramic coated vehicles.

Directions:

Shake bottle well. Apply to a clean, wet vehicle.

Foam Cannon / Foam Gun:
Add 90 ml product to a 1 L foam cannon bottle, then fill with water to 1 litre total volume (1:10 dilution). Foam evenly onto the vehicle and rinse immediately using a pressure washer.

Mist Application:
Mist 5–7 sprays per panel onto the surface. Work one panel at a time and rinse immediately. Rinse adjacent panels to remove any overspray. Apply to wet surfaces only.

Do not allow the product to dry on the surface. Use on cool surfaces only, surface should not exceed 30⁰C (86⁰F). Avoid direct sunlight.

With all chemicals always do a small, subtle test spot first. Do not let freeze.